The lubricating oil filter is composed of filter system, heating system, vacuum system, active control, protection system, cooling system, etc.

1. Filtration system:

The filter is cylindrical placed vertically for easy protection.

The oil filtering equipment is equipped with two more filters. A pressure gauge is installed on the filter to monitor the pressure difference through the filter. The filter must be cleaned every time the filter is filtered the pressure difference on the filter is greater than 0.3Mpa at normal operating temperature.

2. Heating system

The heater of the electric lubricating oil pump is installed in a carbon steel container in the form of a sealed fin tube. The multi-loop heating system enables the oil to be evenly heated in the heater without any dead oil zone.

The number of heating elements depends on the excessive oil flow of the oil filter. The scale is considered to be 1w/cm area, which gives smooth heating. During the heating process, local overheating will never cause oil cracking aging. This ensures that the oil will be overheated burnt. It is necessary to drain the oil the heating container to remove the heating element.

3. Vacuum system:

The vacuum system consists of vacuum separator, vacuum pump, condenser, cooler other parts. Using the principle of "cavitation", the touch area of ??the oil in the vacuum separator has been expanded hundreds of times, the "cavitation" system has continuously increased the surface area of ??oil transpiration, the transpiration interface has been continuously updated to the greatest limit. Increase the oil travel in the vacuum system static moisture evaporation area.

4. Active control protection system:

The active control system is composed of a liquid level controller, a motor, a protection element.

5. Cooling system:

It is composed of radiator, cooler, water reservoir other parts. The steam other gases declared in the vacuum separator, the automatic lubrication pump enters the cooler after passing through the radiator, is reduced to water collected by the water reservoir, the monotonous gas is discharged by the vacuum pump, then the vacuum pump is protected.

When the machine is working, the oil passes through a special filter with high efficiency large dirt holding capacity to remove impurities. Using a special water separator a personalized vacuum separator, it uses lipophilic hydrophobicity the principle of "cavitation" to make the water in the oil get fast under the conditions of low heat, high vacuum, large appearance, high pumping speed. Vaporization transpiration are discharged by the vacuum system.